View Single Post
Old 07-05-2011, 08:16 PM   #1
artemis53
Scooby Newbie
 
Member#: 260497
Join Date: Oct 2010
Chapter/Region: SCIC
Location: Los Angeles, CA
Vehicle:
2006 2.5i
OBP

Default need help with 06 obp...

I got this car used, and apparently the guy before me decided to smoke the tail lights with the rust-oleum spray...thats not really a problem, I want to re-do it better so I would like advice on that, but my main concern is:

They didnt think to take the housings OFF the body, spraying them while on the car, leaving spray paint all over the body. Do you think I may be able to get rid of this by hand, or will it need to be agressively handled by sand paper/rotary?

Mind you, I have used a claybar on it, obviously didnt do anything. I also tried meg's UC by hand and that didnt do anything, at least noticeable...so IDK...ideas/suggestions?

I do want to get a nice DA for my car. I have a dewalt 11k RPM angle grinder a buddy had modified with a speed selector all the way down to 1k RPM, I was thinking about trying that out with an attachment as a rotary, but obviously I am VERY scared and hesitant of using that just yet.
* Registered users of the site do not see these ads.
artemis53 is offline   Reply With Quote