View Single Post
Old 07-18-2011, 03:29 PM   #53
2point0
Scooby Specialist
 
Member#: 150248
Join Date: May 2007
Chapter/Region: SCIC
Location: San Diego-ish
Vehicle:
'13 BRZ Ltd WRB
'67 Mustang

Default

Quote:
Originally Posted by FromEvoToRS37 View Post
I want to do this so bad but don't want to mess up the outers and don't feel like payin that much to a tint shop. Do you have to take the housings off the car to apply them?
No, you can keep them on. It might be hard to hold everything steady if you remove the lights (unless you have a buddy helping).

I did my own and feel that I rushed it a bit. It wasn't hard, really. Just time consuming and you have to be patient with the material. It's easy to heat it up too much and stretch it all funky. You kind of tuck the vinyl into the gaps around the light, then when you're all done, just run a razor blade along the gap to cut off excess.
* Registered users of the site do not see these ads.
2point0 is offline   Reply With Quote