View Single Post
Old 11-25-2011, 05:26 PM   #1
focushere
Scooby Newbie
 
Member#: 247506
Join Date: May 2010
Location: Syracuse, UT
Vehicle:
2004 Forester XT
Silver

Thumbs down Evco Ogden experience

So i bent my oil pressure line on the Pasanger side that feeds from the head to the turbo. I removed my intake and cut the line to get it off. I rather not upgrade it to a stock line (55 bucks from sub dealer, very cheap but if i do it again it will piss me off ). So i went to EVCO House of Hoses in ogden to see if i can get a custom piece made, open to all options and comments.
Very disapointed in there service they said they cannot get my size of Banjo fitting (12mm) and that the one on the firewall side (T style banjo) is a "custom" piece, i tried explaing that i could just use a single banjo then T it, they looked at me like i was nuts.
So here are my options after searching just want to get your inputs and opinions all are welcome. if someone knows were i can get the banjo fittings or even a shop ill buy them then just go back for the breaded lines they should be able to do that...... Thanks in advance

http://www.treadstoneperformance.com...l+Feed+Fitting+


http://www.pandlmotorsports.com/osCo...roducts_id=435

http://www.bptstore.com/BPT-Subaru-S...Line_p_89.html
* Registered users of the site do not see these ads.
focushere is offline   Reply With Quote