View Single Post
Old 12-17-2011, 01:27 AM   #9
jegomes
Scooby Newbie
 
Member#: 303039
Join Date: Dec 2011
Location: Minneapolis
Vehicle:
2006 WRX

Default

Linky to the product manual...

http://www.kenwoodusa.com/UserFiles/...ls/kscsw10.pdf

it has a few different ways to connect it, you could just use the wires that are there from the factory unit as it supplies speaker signal power and ground, but if your looking for control from your aftermarket deck theny your best off running RCA's you will also need a 10amp supply of constant (battery) power as well as a switched 12v turn on, which you should find as a blue/white on the back of your aftermarket deck..
* Registered users of the site do not see these ads.
jegomes is offline   Reply With Quote