View Single Post
Old 12-22-2011, 01:31 PM   #4
lavid2002
Scooby Specialist
 
Member#: 226864
Join Date: Oct 2009
Location: southern NJ
Vehicle:
2005 PSM WRX
18.5lb. 93 oct, DP, UP

Default

When I did my clutch I put the throwout bearing on the clutch fork, then mated the tranny to the engine. I had to press the clutch a few times to get the TB to seat right into the pressure plate because the clutch would just stick to the floor. How did you assemble yours?
* Registered users of the site do not see these ads.
lavid2002 is offline   Reply With Quote