View Single Post
Old 02-03-2012, 02:21 PM   #1
quoiasdaddy
Scooby Specialist
 
Member#: 147711
Join Date: Apr 2007
Chapter/Region: NWIC
Location: Billings,MT
Vehicle:
2002 WRX/Stg 2
PSM

Default Stg 2 on a recovered ECU

I just got my ECU and new V2 AP back from Cobb. I had to send in my ECU to be recovered because when I tried to flash Stg 2 with my old V1 a bad battery caused it to get stuck and thus throwing all kinds of CELs and basically rendering the ECU useless. Anyway it is now fixed and ready to go back in my car. Once I put the ECU back in should I run the car stock for awhile before I flash to Stg 2? My only mods are a turboback that I recently had installed. MY car is an 02 WRX and I just don't want to cause any more problems. So my question is can I flash it right away or should I run it stock for a couple days before I flash it? I just don't want to mess anything up again so I want to be safe, any input would be greatly appreciated. Thanks,
* Registered users of the site do not see these ads.
quoiasdaddy is offline   Reply With Quote