Thread: Ask a tuner...
View Single Post
Old 02-06-2012, 11:02 PM   #543
granny
Scooby Specialist
 
Member#: 283145
Join Date: May 2011
Chapter/Region: SWIC
Location: Avondale, Arizona
Vehicle:
1997 LEGASTi Wagon
PowerflexUSA-@grannywagon

Default

Quote:
Originally Posted by P3Auto View Post
If you must just note the exit point of the pipe and make sure there is nothing hanging around it like rubber, wires, etc. Lots of guys do this for some reasons and they are usually ok but its going to be insane how loud it is lol...

We have some stock mid sections and mufflers from various Subarus. Some of the stock stuff you could have or cut up if you can make it work. Cutting and welding bends isn't that hard with some patience.

Also consider getting a quote from a muffler shop. You may be surprised how little they may charge you to bend a little pipe and slap a generic high flow muffler on there. I have in the past used midas for quick temp work on muscle car projects and was surprised what a good deal I got.

Good luck and be safe. If your driving in Anchorage with the open pipe don't expect to get far before the APD get ya!! Been here done that....
I'm gonna have an exhaust shop bend me up a 3" exhaust but right now I don't have a lot of money to spare.
* Registered users of the site do not see these ads.
granny is offline   Reply With Quote