View Single Post
Old 02-09-2012, 03:23 PM   #13
2milehi
Scooby Specialist
 
Member#: 81633
Join Date: Feb 2005
Location: Dillon, CO
Vehicle:
'98 RS-T
Blue

Default

Quote:
Originally Posted by B.R.E.D View Post
I've got a few I've been meaning to post but since I had to deal with this yesterday Ill post it now.

Use a large putty knife on both front corners of the oil pan to get it off without damaging the mounting surface.

Just gently tap it between the pan and the block.


Ill post more later about splitting cases, do not ever under any circumstance pry the case halves apart.
I have seen a scissors jack used in the bell-housing area of the engine to split the block. Anything wrong with this method?
* Registered users of the site do not see these ads.
2milehi is offline   Reply With Quote