View Single Post
Old 02-16-2012, 08:05 PM   #117
68Cadillac
Scooby Specialist
 
Member#: 95901
Join Date: Sep 2005
Chapter/Region: SWIC
Location: Las Vegas, USA
Default

Quote:
Originally Posted by NutBucket View Post
How hard is it to get the bearing off and on?

Getting ready to have fun with this rebuild.
I have the fortune of owning a shop press. It's the MOST dangerous tool I own, by the way. I shattered a brake rotor with it once. I give it serious respect.

Anyway, I used it to press the bearing out, off, on, then back in. Had I not owned a press I could have used a deadblow and some deep sockets to move the bearing. The shaft and bearing come out the front of the pump past the big C-Clip that you removed in a previous step.
* Registered users of the site do not see these ads.
68Cadillac is offline   Reply With Quote