View Single Post
Old 03-05-2012, 10:57 PM   #1
HERSHEY
Scooby Specialist
 
Member#: 148549
Join Date: May 2007
Chapter/Region: NESIC
Location: RI
Vehicle:
95 RHD GC V7 STi
04 WRX, Sold the BlackSTi

Default Congratulations HERSHEY and his Monster STi, Nasioc's Top Scoob 028



Not really sure where to start. I am a driving instructor with ADSI in Rhode Island, we teach State Police training, vehicle dynamics classes, cornering, car control classes and most importantly AutoX courses. This is about my 14th Subaru, I currently own 3 as you can see in my profile. I flew to Japan last year and bought a V7 STi and brought it back to rebuild my 95 impreza which is extremely fun too! I am not sponsored, and prefer to be that way since I like having zero stickers on the car! This sti though sticks to the ground with the wide setup. It handles as if it were on rails, it's a completely different level when you run 11.6" wide slicks all the way around! I really care about this car in particular and am very pleased with the way it looks and performs!


I couldn't have done this all without the help from my good friend John L, Joe P, my g/f, Wicked Innovation/Wicked Bodyworks (Matt, Tom, Jimmy, Jay), and of course Joshua Hanley photography.

Built Block:
EJ257 (703)
CP 100mm Pistons
Manley H-beam Rods
ACL HX and H mix Race bearings
STI 400 series Nitrided Crank
P&L Modified Oil Pump
Heads decked, "cleaned up" and pressure tested
ARP Head Studs
Balanced rotating assembly to 10k
APS turbo Inlet
Group N Motor mounts
Cosworth Air Pump Delete
Cosworth timing belt guide
Gates kevlar reinforced timing belt
A/C Delete
GMS 160 T-stat
NGK 1 step colder plugs
ACT 6 Puck sprung clutch and ACT Xtreme Pressure Plate
Being built by me and tuned by EFI Logics
STRI DSD Slim II Gauges 60mm
Oil Pressure
EGT
Oil Temp
ATI triple dash pod with CF face.
STRI Fuel Pressure Gauge
STRI Boost Gauge
HKS Limited Edition Oil cap
"Lots of" -an fittings, Pro-Lite 350 hose and hose finishers.
AEM 3.5 BAR MAP Sensor and Cobb MAP adaptor block.

Engine:
Perrin Garrett Rotated 35r
Perrin up-pipe
Tial 44mm V-band EWG
Prodrive EBCS
APS DR525
Perrin CAI
NGK 1 step colder plugs
Perrin Turbo inlet
Perrin Downpipe
1000cc top feed fuel injectors
Perrin Top Feed fuel rails & -an fittings
Grimmspeed TGV Deletes with coated housings
Aeromotive FPR with -an fittings
Gimmick aluminum radiator
Gates Alt. Belt
Gimmick radiator hoses
HKS Carbon Ti
APS 50/50 BOV
Walbro 255lph Fuel Pump
Perrin crank pulley
Perrin coolant overflow tank
Crawford Type 2 AOS
Snow performance stage 2 progressive methanol kit
Perrin EL header (wrapped)
Optima Red Top Battery
Much heat shielding and wraps!!!
Beatrush forged pitch stop mount
Paranoid Fabrications Grounding kit
HKS "Limited" oil cap
Gallery Fresh (Sonoma Red) bolt kit

Transmission and Chassis:
Group N tranny mount
TIC Transmission Crossmember mounts
Cobb Front shifter bushings
TIC Rear shifter bushing
Cobb Short Shifter
WC Lathe Works 1lb sphere
Paranoid Fabrications 3 pc. front subframe
Cusco H-brace
Unabomber Sexy rear end kit
Whiteline Front strut tower brace
Whiteline Rear strut tower brace
JDM Lightweight front bumper beam
Beatrush aluminum pilot shaft bushings
Kartboy exhaust hangers
TiC Giuyngmyo Fender Cowl Braces

Suspension and Braking:
BC Racing Coilovers
Cobb F/R swaybars
Cobb F/R endlinks
DBA 5000 slotted front rotors
DBA 4000 slotted rear rotors
Ferrodo DS2500 F/R brake pads
Goodrich Stainless lines
Castrol Synthetic Brake fluid

Safety and Interior:
AutoPower Race Roll Bar with Cross and Harness Bars
Sparco "Ultra" race seats
Sparco harness bar
G-Force 5pt. harnesses
Back seat delete with custom aluminum pan
Red light mod to ALL switches and knobs (HVAC, Gauges, Window and Meth Switches, Radar Detector, Speaker switch, etc.
JDM hazzard button
AEM wideband
Labonte methflow gauge
Prodrive floormats with aluminum heel guard on driver mat
Black WRX door panels and carpet
COBB Shift Knob (flat black)
JDM CF mirror cover
Hardwired Beltronics 995 Radar
Dash painted black (S204 style)
Dual JL Audio Separator kit for the front two speakers
10" JL Sub with custom fitted box in trunk with cleats for ease of removal for autocross, etc.
Rockford Fosgate Amp with a cutoff bypass switch and connection for ipod input.
Blacked out interior (Pillars, Trim + Headliner (all painted & dyed black))


Exterior:
Seibon Rear Carbon Fiber Diffuser
CF Rear exhaust shield
CF Front Lip with DIY lip addition
Fog light cover mod for intake
Replica Symms rear wing
NRG Carbon Fiber 1pc roof vane
Tein hood dampers wrapped in Sim...CF
Carbon Fiber B-pillar covers
Lightwerkz front headlight clearing and painting
6000K HID bulbs
JDM Yellow High beams
Carbon Fiber grille and blacked out front STI badge
Custom rear LED tails
All bulbs changed to clear,red,mirrored or LED
Hella Horns Hidden (High + Low tones)
I-badge front
Black front STI badge
Nukabe rear tow hook
Cut, rolled and sealed rear fenders
Tinted (20% front windshield with a 5% sunshade 1/3 of the way down, 5% on the remaining 5 windows)
Custom full wide fender flair kit all around (painted OBP to match)
Custom Front bumper side braces
Enkei RPF1's (Black) 18x10.5 +15mm offset
Hoosier R6's 295/30/18
Shaved + Debadged rear trunk lid
Muteki closed ended lugs

[center]





Obviously lots of sliding so I went wider...


Oh man, going to get flamed for this one...




... and since I need a video, here's an old one before the wide setup on the old horrible tune:


More pics on the next page or click:
http://forums.nasioc.com/forums/show...2&postcount=66
* Registered users of the site do not see these ads.

Last edited by HERSHEY; 04-16-2012 at 03:00 PM.
HERSHEY is offline   Reply With Quote