View Single Post
Old 03-21-2012, 11:18 AM   #74
Clutch987
Scooby Newbie
 
Member#: 291454
Join Date: Aug 2011
Chapter/Region: MWSOC
Location: Toledo OH
Vehicle:
2011 BJV STI 4-Door
WRB

Default

Hopefully quick question for you guys. Long story short, Last October I had my '11 STI in the shop to get a cracked front bumper replaced and while it was there someone backed into it and hit the trunk lid around the bottom right corner of the license plate. They put on a new trunk lid, painted, and then I checked their work. Then they put the license plate back on. Here is my problem, the corner of the plate was bent in slightly, and rubbed a small hole through the paint and has started to rust a bit.

Whats the best way to patch this up? I assume some sort of paint touch up pen for the Paint (WRB). Anything need to be done to the spot for prep?
* Registered users of the site do not see these ads.
Clutch987 is offline   Reply With Quote