Thread: Gas Gauge
View Single Post
Old 04-08-2003, 07:45 PM   #9
matt8416
Scooby Newbie
 
Member#: 34929
Join Date: Apr 2003
Location: MN
Vehicle:
2004 sti
07 Lexus Breakwater Blue

Default fuel gauge

due to saddle type tank you have two sending units in series this could effect reading.get a copy of wiring diag by grounding connector the gauge will read empty.

with tank below half tank remove back seat and carpet in cargo area 2 access covers can be seen / remove - top of fuel pump units can be seen dis connect elect & fuel lines,remove nuts from the stud that hold units in place on tank. remove both fuel pumps with a ohm meter on leads to senders you can check for opens as you move float up and down

be VERY CAREFUL when reinstalling pumps DO NOT - DO NOT over torque the nuts and make sure the gasket is set correctly or you will get a e-light for evap
* Registered users of the site do not see these ads.
matt8416 is offline   Reply With Quote