View Single Post
Old 04-01-2012, 08:36 AM   #21
Turbo27
Scooby Newbie
 
Member#: 270182
Join Date: Jan 2011
Chapter/Region: MWSOC
Location: Louisville, Ky
Vehicle:
2003 WRX
OBP

Default

Little update:

Put the RCE yellow springs, koni shocks, MSI street camber/caster plates on yesterday. Attempted to also install my whiteline roll center kit and got to the last ball joint and broke the bolt off in the knuckle. After looking online I see that several other people have ran into this same issue. So I put the oem one back on the other side and just left the tie rods on. Looks like im going to just go ahead and buy 2 new knuckles and bearings so I can swap them in an afternoon without having the car down too long. It's pouring rain or else Id take some pics of it at the new ride height. I'm not really happy with how much these camber plates raise the front. The car hardly looks lowered. I'm still going to try and get some RCE lowering plates for the front eventually. That is all for today, I'm getting an alignment tomorrow and will post pics as soon as i get the chance.
* Registered users of the site do not see these ads.
Turbo27 is offline   Reply With Quote