View Single Post
Old 04-06-2012, 02:52 PM   #25
efiniluvr
Scooby Newbie
 
Member#: 107170
Join Date: Feb 2006
Location: Bay Area
Vehicle:
2002 ver 7 EJ207 WRX
WRB

Default AVCS wiring help

Alright, I knew I would have a hard time with this. I am trying to follow the DS1 Motorsports wiring instructions and I am confused. Before I get to the my question, here is how to get to the ECU.

The ECU is located under the carpet on the passenger foot well, you will need to peel back the carpet and loosen 4-6 10mm nuts.

This is what you'll see when you peel the carpet back


Here is the ECU, bolted down to the floorpan by two 10mm nuts:


So on to my wiring question: On page 3, here are the instructions:


So which connector is B84, by the count of the ECU pins, it looks like the middle of the five is correct, isn't it? If it's the middle one, then it doesn't match up to the picture in the instructions.


Secondly, the first instruction under "JDM" specifies to move Pin 4 to Pin 6, on the connector that I think is B84, there is no wire in the Pin 4 location.

Am I looking at the wrong thing??
Thanks
-Jeff
* Registered users of the site do not see these ads.
efiniluvr is offline   Reply With Quote