View Single Post
Old 04-06-2012, 10:52 PM   #28
efiniluvr
Scooby Newbie
 
Member#: 107170
Join Date: Feb 2006
Location: Bay Area
Vehicle:
2002 ver 7 EJ207 WRX
WRB

Default

Quote:
Originally Posted by RexWagonWA View Post
From looking at your diagram, I think B84 is at the left side of the connector in your picture. It also is missing Pin 4.

From your documentation:You may have the wrong harness or ECU? Unfortunately no one can call DS-1. Or could the documentation not match your hardware?

If you look at the pin out, the middle connect corresponds to 84 on the DS1 instruction. (Count the number of pins and it'll match). Unfortunately you cannot call DS1 but if you look at this picture, it's a match with the diagram:

Just make sure you're reading the pin-out with the plug facing you Now the pin 4 is in the correct orientation!!!

Like this:
* Registered users of the site do not see these ads.
efiniluvr is offline   Reply With Quote