View Single Post
Old 04-12-2012, 07:05 AM   #58
424wrx
Scooby Guru
 
Member#: 171948
Join Date: Feb 2008
Chapter/Region: Tri-State
Location: new york
Vehicle:
2008 vf52wrx12.6@108
11 forester,14 legacy

Default

Quote:
Originally Posted by BlackLabelFox View Post
Ya I have some extra clamps around somewhere. I'm pretty excited to get it all set up. Did you have enough room to wrap each runner individually or did you have to pair them up?
i wrapped each one individually. it takes a little patience. keep it tight with plastic zipties as you work done each tube. then remove them when finished. the stock uppipe is a pita to remove. i had to lift the pass side of my engine about an inch to get room to pull it out from the bottom.
* Registered users of the site do not see these ads.
424wrx is offline   Reply With Quote