View Single Post
Old 04-28-2012, 06:50 PM   #64
fluke177
Scooby Newbie
 
Member#: 318394
Join Date: Apr 2012
Default

Quote:
Originally Posted by Noah View Post
That seems pretty strange, as the 7058 chip uses Protocol C or so it says when you set it to flash to a 7058. Since it seems you are having a problem getting the initial connection to the ECU I would try swapping your TX and RX lines and see if that changes anything. first.

Alternately you could try using ECUflash recovery mode.
Hi Noah,

I used ECUflash, But it not work.

How to supply 12V to ECU?

I connect 12V B135 .5,6,19 & B136 .7 &B137. 15

GND B135 .1,3 & B137 .12

Does any pin I missed?




Fluke
* Registered users of the site do not see these ads.
fluke177 is offline   Reply With Quote