View Single Post
Old 05-04-2012, 08:55 PM   #57
bsdoig
Scooby Newbie
 
Member#: 199980
Join Date: Jan 2009
Location: Statesville, NC
Vehicle:
2005 VF39'ed WRX
OBP

Default

Quote:
Originally Posted by Bikelok View Post
^^^bsdoig, this is what probably happened to you. You have to be VERY VERY careful that the threads are clean and you can thread it in with your hand all the way before using a wrench.
Good luck.
No I don't think so…….I was able to pull he bolts right back out without any issues. Threads were tapped and clean. I could run the bolt by itself all the way through without any issues. It was like where the brass meets the subframe it was just collapsing and wouldn't get tight. I'm gonna leave them off for now since I didn't like the way they felt when tightening.

What are they suppose to be tightened to?
* Registered users of the site do not see these ads.
bsdoig is offline   Reply With Quote