View Single Post
Old 05-28-2012, 07:37 PM   #1
poly_poly-man
Scooby Newbie
 
Member#: 262988
Join Date: Nov 2010
Chapter/Region: Tri-State
Location: Rochester Institvte of Technor
Vehicle:
2002 WRX Wagon
WRB

Default IAT relocation questions

I'm working on setting up a carberry rom on my car ('02 wrx) - it's not going badly.

I'm thinking about setting up a relocated IAT of some sort for more accurate tuning. My biggest goal, however, is to save money (short of having an unusable car).

Thinking about the GM IAT, I was wondering where it is recommended to put it (specifically - I realize that it's supposed to go post-IC and if possible in the intake manifold), if I could do it without welding a bung, etc. Basically, what's the cheapest/easiest way to do this?

Or, my other thought - why not just take the IAT out of the MAF housing, then drill a hole in the IC-TB hose, shove it in and seal with silicone or so?

any tips appreciated.
* Registered users of the site do not see these ads.
poly_poly-man is offline   Reply With Quote