View Single Post
Old 07-04-2012, 02:24 AM   #1
Subabu
Scooby Newbie
 
Member#: 198937
Join Date: Jan 2009
Chapter/Region: VIC
Location: The burbs
Vehicle:
2008 WRX STI
Aspen White

Question HELP reading datalog #'s

Hey guys and gals,

This is the first accesport data log I have done with the new car. The previous owner had a very reputable shop tune the car. Keep in mind the boost is in kpa converted it's max boost is around 22 psi on the first run... however the boost on the second run done 20 seconds later is much lower. Here is a list of mods.

GT2871-RS custom turbo-rotated kit with v-band clamps and externally Tial gated up-pipe plumbed back into the downpipe.

Custom fabed enclosed cold air air intake box

DW 750 injectors

AVO fuel pump

Aquamist HFS 6 meth injection
Using -40 blue washer fluid roughly 40meth-60water

TGV and airpump deletes

Rocket Rally AOS

Heatwrap and DEI turbo blanket etc.

Blitz catback-modified to full 3'' to mate with the downpipe.

I did two 100 percent throttle pulls in fourth gear from approx. 2500-3000 rpm up to 6000ish

Can anyone with some knowledge help me decipher the numbers? I have watched a few of cobbs youtube video's and did some searches. I can't see any problems with regards to fueling or knock based on my limited knowledge. I may try another run with the injector duty cycle as well as change the boost from Kpa to PSI. Any input or response would be greatly appreciated!

2008 WRX STI
Aspen White


Run#1

https://docs.google.com/spreadsheet/...FE&output=html

Run#2

https://docs.google.com/spreadsheet/...VE&output=html


Many thanks!

Randy
* Registered users of the site do not see these ads.

Last edited by Subabu; 07-04-2012 at 02:31 AM. Reason: Added google spead sheet
Subabu is offline   Reply With Quote