View Single Post
Old 07-13-2012, 07:39 PM   #207
extransam
Scooby Newbie
 
Member#: 287109
Join Date: Jun 2011
Chapter/Region: SCIC
Location: Santa Monica, CA
Vehicle:
04 WRX 2.2 Hybrid
WRB

Default

I am getting a new rear bumper installed, and the body shop I am using has agreed to prime and spray my STI fog light covers if I prepped them.

I do not have an STI, and I do not want to pretend like I do have an STI, so I used a razor blade to remove the decals.

I bought 180, 600, and 1000 grit sandpaper.

Here are the results after finishing with 180. I do not have a before picture, but there were the typical rock chips you would expect from a CA car.

How should I approach it from here? I am afraid I might have feathered it out too much already and reached the bare plastic.

Any advice would be greatly appreciated.

* Registered users of the site do not see these ads.
extransam is offline   Reply With Quote