View Single Post
Old 07-20-2012, 11:15 PM   #84
scootarida1
Scooby Newbie
 
Member#: 154534
Join Date: Jul 2007
Chapter/Region: Tri-State
Location: Wilkes-Barre, PA
Vehicle:
2005 Forester XT
Borg Warner S261

Default

Quote:
Originally Posted by Keif View Post
I noticed there's a directional arrow on the solenoid and there's a diagram on the hood for the purge system, if anyone gets confused.

__

I was able to get it sorted today. I was hoping to find a bolt for the nipple on the manifold but had no luck. I even tried a big industrial fastener place.

The thread pitch is 0.90mm and I believe the diameter is 8mm? Might be able to get it online.

But Autozone had some nice nipple caps.



Good stuff. Happy to clean up the engine bay a bit and remove something that could cause issues.
I believe the thread pitch is 1/8 NPT thread. Also how did you route the hoses based on the arrow?
* Registered users of the site do not see these ads.
scootarida1 is offline   Reply With Quote