View Single Post
Old 08-22-2012, 08:36 PM   #14
Bad Noodle
Scooby Specialist
 
Member#: 174442
Join Date: Mar 2008
Chapter/Region: Tri-State
Location: NNJ
Vehicle:
2007 SuperWagon
I don't spell well

Default

Awesome, thanks for all the advice.

yarrgh, good point about the rear cover. It was leaking quite badly. I thought it was the oil pan gasket, but it turns out it's that cover. +1 on getting a new one.

I'm not sure about the pullys.
the one with teeth spins freely but is loud like a skateboard wheel
The other ones are quieter but seem slightly off axis,
The tensioner seems ok. Doesn't spin for a long time
Water pump seems a little jerky when you spin it

but the good news is that the block mating surfaces are flat.
the bolts all mesh really well, no problems there. the only defect I found on them are:

I think they should be ok to be reused. It looks like a manufacturing defect rather than threads getting warped.

So how's this for a shopping list?
- fel-pro gasket set
- rear crank case cover
- pully set (no tensioner)
- timing belt
* Registered users of the site do not see these ads.
Bad Noodle is online now   Reply With Quote