View Single Post
Old 08-25-2012, 10:26 AM   #64
CatfaceType-R
Scooby Guru
 
Member#: 81102
Join Date: Feb 2005
Chapter/Region: MWSOC
Location: Brushyoteefs@dentists.cats
Default

Get these, too! . On my wish list, someday...

Quote:
http://www.curtbrownracing.com/ceramic_bearing_8.html

For the last three* years I have been using ceramic* wheel bearings in my cars with amazing results, I was keeping it under my hat for the most part just to hold that extra edge but im getting old and don't need to keep breaking records and chasing fast times.

Used by Nascar, Indy, Rally teams and Top fuel tems for years.

The ceramic ball bearing hubs I use have 1/10th the friction of a steel ball, 60% lighter, *they are 100% round grade 5 Silicon Nitrate, we use special ultra low friction grease, micro polished races. Ceramic bearings will far outlast the factory steel units as they produce nearly no heat or friction, the car WILL pick up MPH and ET at the dragstrip, run more consistant and faster laps on the road course and yield better fuel economy eventually paying for themselves.

Evo's go through wheel bearings rather fast, why not spend a little extra $$ and have a set that will outlast the car and give you an edge everytime you drive the car.

*2003-2006 Mitsubishi Evolutions:
$1649 four all four hubs on an exchange basis with a $200 refundable core charge.
OR.
$2100 shipped for four brand new hubs ready to bolt in.

*
$1550 for 90-94 DSM press in upgrade

2G DSM front special $850 for NEW hubs with ceramic upgrade
Also*ceramic wheel bearings for:
Toyota Supra
Honda S2000
Subaru STI and WRX
* Registered users of the site do not see these ads.
CatfaceType-R is offline   Reply With Quote