View Single Post
Old 09-01-2012, 10:45 PM   #1
Soarer
NASIOC Supporter
 
Member#: 134872
Join Date: Dec 2006
Chapter/Region: Tri-State
Location: Danbury, CT
Vehicle:
98 Legacy GT Wagon
STi Swap

Default EJ22T - Should this hole be threaded?

I was tearing an ej22t motor down to the short block and noticed that there was a weird brass plug with RTV sealant around it plugging a hole right behind the EJ22 casting mark. I pulled it out. My question is, what is this hole for and should it be threaded or smooth? I'm wondering if a prior owner stripped it out. Here is a pic:
* Registered users of the site do not see these ads.
Soarer is offline   Reply With Quote