View Single Post
Old 09-03-2012, 11:53 AM   #20
fr0st_wrx
Scooby Specialist
 
Member#: 126717
Join Date: Sep 2006
Chapter/Region: BAIC
Location: 209//Norcal
Vehicle:
2006 WRX
OBP

Default

Quote:
Originally Posted by Type2 View Post
Do you have any pics of your old setup? Re: aluminum piece - how long and what diameter? What about the 45 degree bend coupler? Where did you source the intake w/ integrated MAF? Did you get it from Perrin? How did your setup run? Did you run EWG?

Thanks!
There may have been 2 aluminum pieces I forget, the way it was setup looks kinda like the way perrin adapts their fmic to rotated.. like a """\__

The aluminum piece was about 3 inches long 2in diameter(same as the compressor outlet to the ic),it was long enough to get 2 clamps on the ends for the silicone pieces. the 45 bend came with about 6inches on each side of the bend and I trimmed it to fit. I dont have any pictures but it was setup with maf on a cold air intake, purchased from KStech designed for the perrin kit. It had an EWG on it, but I never got it fully tuned with the tmic, got a base tune and ended up going fmic because the tuner didnt wanna tune the sti tmic. It has been done though and will work.

If youre going to do it Id get a larger tmic to do it with. Or at least a GR sti tmic.

Gl
* Registered users of the site do not see these ads.
fr0st_wrx is offline   Reply With Quote