View Single Post
Old 09-29-2012, 04:06 PM   #84
AkumaMotorsports
Former Vendor
 
Member#: 214570
Join Date: Jun 2009
Chapter/Region: Tri-State
Location: NJ/SLC
Vehicle:
2008

Default

I did make the CF NACA duct, but I do not have a 3d printer. I was able to make a mold and do a wet layup. It is not structural, so I was not worried about maximizing the strength of the piece.

thx.

John
* Registered users of the site do not see these ads.
AkumaMotorsports is offline   Reply With Quote