View Single Post
Old 10-04-2012, 09:11 AM   #6
jegomes
Scooby Newbie
 
Member#: 303039
Join Date: Dec 2011
Location: Minneapolis
Vehicle:
2006 WRX

Default

Yes... if you pull the auxiliary plate out you can open it up and pull out the circuit board... from there you can solder directly to it. I usually but the cord I'm going to use and then plug it into the Jack on the board then use my dmm to check for continuity with the pins on the board
* Registered users of the site do not see these ads.
jegomes is offline   Reply With Quote