View Single Post
Old 10-04-2012, 08:55 PM   #398
biodude
Scooby Specialist
 
Member#: 271720
Join Date: Jan 2011
Chapter/Region: Tri-State
Location: NEPA
Default

Quote:
Originally Posted by derk View Post
can you guys do anything for a pair of EJ207 AVCS heads going on an EJ22T block? i want to open up the combustion chamber on the 207 heads for the 22T bore

I had this exact thing done to mine when I sent my heads out, but I don't want to advertise for an other vendor in EQ's thread, so I wont say where here. For all I know EQ can do this as well.

all that needs to be done is the side widened a little and then blended back into the chamber, plus a little deshouding behind the valves doesn't hurt. My combustion chamber final size was on 51cc so I didn't loose much in my compression ratio either.
* Registered users of the site do not see these ads.
biodude is offline   Reply With Quote