View Single Post
Old 10-05-2012, 05:34 PM   #8
bswilmington
Scooby Specialist
 
Member#: 217563
Join Date: Jul 2009
Chapter/Region: South East
Location: Eden NC
Vehicle:
2006 Sti 12.68 @ 108
321WHP 422WTQ dynojet SAE

Default

Quote:
Originally Posted by Bamofo
i built a couple motors with king bearings and wasnt thrilled at the prep work i had to do to them including deburring to make them the same quality as a ACL bearing. If the customer is doing it themselves ive been suggesting Cosworth as they are pretty close to on the money. if im doing it i use ACL both h and hx. Bearings is not somewhere to cut corners... for the extra 40 bucks that the cosworth ones run they seem to check them twice before sending them out. just my 2 cents.
I've already ordered and got a set of the kings since I have heard pretty much all good things about them.

For what I read in past IIRC Cosworth bearing are made by ACL.
* Registered users of the site do not see these ads.

Last edited by bswilmington; 10-09-2012 at 12:17 AM.
bswilmington is offline   Reply With Quote