View Single Post
Old 10-08-2012, 06:39 AM   #4
fastblueufo
Scooby Specialist
 
Member#: 212154
Join Date: May 2009
Chapter/Region: South East
Location: Ed@fastperformancetuning.com
Vehicle:
02 billet crank
pauter rods, pt5857, E85

Default

Quote:
Originally Posted by eg33GC View Post
your surface finish may not have been as smooth per cometic's tolerances

the gaskets aren't bad, they're so good that shoddy machine shops/idiot psuedo-builders here just bitch when their shortcomings result in failure.
I assure you it wasn't anything to do with the build process or mchining. I doubled checked the surfaces with a mac straight edge and was WAY within spec. Also used a digital snap on tq wrench. I was told by quiet a few peeple not to use cometic due to not holding boost past 25 psi.
* Registered users of the site do not see these ads.
fastblueufo is offline   Reply With Quote