View Single Post
Old 10-08-2012, 11:49 PM   #10075
OneQuiet22
Scooby Newbie
 
Member#: 311359
Join Date: Feb 2012
Location: Columbus, Ohio
Vehicle:
2012 WRX sedan
OBP

Default

Quote:
Originally Posted by ChesterWRX View Post
threw this in today:

front bushings and rear bushing were a royal PITA using ramps... and I didn't have a wrench big enough to yank off the o2 sensor... but oh well.


scrapped my bumper on a steep driveway... so i threw the lip on there yesterday. it appears I'm not alone in that the spacing on these can be a little whacky. i swapped out the bolts and cheap bushing thingies that came with the kit for regular screws.. they are on there tight after drilling pilot holes, gonna throw some nuts and washers on there later.




Are you running 16in steelies? If so how do you like them? And how was the fitment over the calipers? Im about to do the same for a cheap winter setup.
* Registered users of the site do not see these ads.
OneQuiet22 is offline   Reply With Quote