View Single Post
Old 10-09-2012, 07:40 AM   #33
Bad Noodle
Scooby Specialist
 
Member#: 174442
Join Date: Mar 2008
Chapter/Region: Tri-State
Location: NNJ
Vehicle:
2007 SuperWagon
I don't spell well

Default

Quote:
Originally Posted by NSFW View Post
I have my doubts about the longevity of those nylon screws when you get into boost...
As do I. I did order some McMaster ones that might fit a bit better, but will see. at 20 psi, they need to hold 10 lbs each. Looking at plastic properties of nylon (PA) it seems to have a high yield strength, so it looks like it would be ok.

I really can't think of a better way to isolate the maf. The only other thing I can think of is to bore out the screw holes on the maf enough to insert a plastic spacer between the maf and the screw. I don't like to the sound of that either
* Registered users of the site do not see these ads.

Last edited by Bad Noodle; 10-09-2012 at 08:31 AM.
Bad Noodle is online now   Reply With Quote