View Single Post
Old 10-09-2012, 08:14 PM   #35
EROCS04SBRUSTI
Scooby Guru
 
Member#: 234397
Join Date: Jan 2010
Chapter/Region: MWSOC
Location: Elyria,Ohio
Vehicle:
2004 WRX STI
WORLD RALLY BLUE

Default

ok,for the dp it's the same position setup mostly for stock location group sti the earlier years,but we have bell mouth and stock the flat flange,is it possible to rotate in a way,with a new uppipe setup and dp setup without cutting anything,just bolt on's.I know a dumb question but wondered if it can be done,or too much of a hard turn for the exhaust to exit.Wish I had a welder and knew how to i would spend money on these flanges and try.or could send some your way.
* Registered users of the site do not see these ads.
EROCS04SBRUSTI is offline   Reply With Quote