View Single Post
Old 10-09-2012, 08:21 PM   #1610
VTSubieRS
Scooby Specialist
 
Member#: 90608
Join Date: Jul 2005
Chapter/Region: South East
Location: Vermont & St. Simons Georgia
Vehicle:
2005 STI, '08 3.0R
05 2.5RS, 92 Legacy L

Default

got bored and messed around a little today. I used to have a similar setup on my old 2.5RS so i thought I'd try again. Intake heat shield DIY.

What I used:

Small piece of sheet metal, cut to desired size needed for clearance and fit. Bent to fit. Painted to desired color, or left metal.

Found some random hardware- "c" bracket, and short screw with nut.



Test fit it on the intake, under the hose clamp, against the filter.


Test fit the hardware on the shield


painted the shield red, to match my other under hood goodies.


installed:




Cleaned up under the hood while the paint dried, the shield matches pretty well in my opinion.


I would have used more c brackets if i had them, at least one more. I will put another on eventually, this was a quick mock up to reproduce the one I had made for my 2.5RS
* Registered users of the site do not see these ads.
VTSubieRS is offline   Reply With Quote