View Single Post
Old 10-09-2012, 08:53 PM   #943
jozeppi
Scooby Specialist
 
Member#: 247473
Join Date: May 2010
Chapter/Region: MAIC
Location: westminster Md
Vehicle:
2007 wrx
wrb

Default

Quote:
Originally Posted by VTSubieRS
got bored and messed around a little today. I used to have a similar setup on my old 2.5RS so i thought I'd try again. Intake heat shield DIY.

What I used:

Small piece of sheet metal, cut to desired size needed for clearance and fit. Bent to fit. Painted to desired color, or left metal.

Found some random hardware- "c" bracket, and short screw with nut.

Test fit it on the intake, under the hose clamp, against the filter.

Test fit the hardware on the shield

painted the shield red, to match my other under hood goodies.

installed:

Cleaned up under the hood while the paint dried, the shield matches pretty well in my opinion.
Nice job looks good
* Registered users of the site do not see these ads.
jozeppi is offline   Reply With Quote