View Single Post
Old 10-15-2012, 12:13 PM   #2340
Evanston Subaru
NASIOC Vendor
 
Member#: 217382
Join Date: Jul 2009
Chapter/Region: MWSOC
Location: 3340 W. Oakton Skokie IL 60076
Default

Quote:
Originally Posted by Aithos View Post
This is what happened to me. I forgot to mention to them I didn't want front plates drilled (the one I saw earlier in the spring had a note that said no front so I was thinking it was common practice on these). So now I have two lovely little holes in my bumper

Of course we have front plates required in Iowa, but I would have preferred to be able to do it myself and make use of the square holes right next to the two. Not to mention there is no assurance that these holes won't strip eventually and my stainless plate will just fall off. My only real complaint aside from forgetting my phone is in the armrest because I'm listening to Pandora through USB...

Those holes wont strip out. At least I have never seen one do it. There is material behind where those holes are that grab the screw. Can't remember what it is though...

Mike
* Registered users of the site do not see these ads.
Evanston Subaru is offline   Reply With Quote