View Single Post
Old 10-18-2012, 01:13 PM   #949
2point0
Scooby Specialist
 
Member#: 150248
Join Date: May 2007
Chapter/Region: SCIC
Location: San Diego-ish
Vehicle:
'13 BRZ Ltd WRB
'67 Mustang

Default

Quote:
Originally Posted by armyssoldierboy View Post
Made my own radiator shroud out of aluminum with my dremel

Is there a slight bend in that? Not sure if this will work for you since it's a thick piece, but when I made mine out of sheet steel, I screwed it down onto an old speaker box so the bend line was at the edge, then used a block of wood and a hammer (wood to soften the blow) and gave it some good whacks to make a nice crease. Rubber mallet worked, too, but nicer with a block to make it smooth.
* Registered users of the site do not see these ads.
2point0 is offline   Reply With Quote