View Single Post
Old 10-27-2012, 02:01 PM   #11
youngxlos
Scooby Newbie
 
Member#: 232169
Join Date: Dec 2009
Location: Lorton, VA
Vehicle:
2002 Hawkeye
World Rally Blue Pearl

Default

I routed the 10ft driver side wires into the cabin, behind the battery and also using the other 5ft conduct tite to protect the wires.

then slit it into the firewall hole.


Now the wiring inside the car to the switch.
here is a picture of my wiring under the dash

thanks jezzy for this post
Pin #1 = RG (red with green stripe) runs from switch to LH and RH leveling motors (middle pin #2 on leveling motor on headlight) White wire from headlight motors
Pin #2 = RY - Red/Yellow line (taken from (Fuse Box under dash) locate FB-7, F/B fuse #5, refer to owners manual) Red wire from headlight motors
Pin #3 = unused
Pin #4 = unused
Pin #5 = unused
Pin #6 = B - black (any ground near fuse box under dash) Black wire from headlight motors
Pin #7 = V - violet (taken from "fog light switch harness" where fog light switch plugs into)
Pin #8 = OrW - Orange with white line (taken from "fog light switch harness" where fog light switch plugs into)

Turn signal, parking lights wiring

Getting the turn signals and parking lights to work is also fairly easy, the stock wiring harness has 3 wires Red/yellow, Black, Black/Green

The 06-07 headlights come with one main plug, it looks like this

the 4 wires on the left of the pictures are the ones you'll need to use, cut them from the harness(cut right where the wires meet the harness as you'll need as much wire as possible)
Remove the harness from the headlight assembly as you wont need to use it anymore.

Using the 3pin connectors connect the wires as you see here on the picture (stock wiring side)

Red/yellow on the top pin
Black in the middle pin
Black/Green on the lower pin

Now the headlight side, ill use an older picture of my previous set up to explain this a little better

you should have 4 wires to hook up, 2 red and 2 black.
Look at the wires carefully as one of the Red wires has 2 Red wires joined before they connected to the pin, that is the parking lights power source wire, this should be the top pin (connects to Red/Yellow wire on stock harness)
Then join the 3 Black wires in the middle pin (connects to Black wire on stock harness)
and last the single Red wire should be joined alone on the last pin (connects to Black/Green wire on stock harness)
this is what it should look like
* Registered users of the site do not see these ads.

Last edited by youngxlos; 10-27-2012 at 02:17 PM.
youngxlos is offline   Reply With Quote