View Single Post
Old 10-27-2012, 02:32 PM   #26
EnderDragoon
Scooby Newbie
 
Member#: 300176
Join Date: Nov 2011
Chapter/Region: SWIC
Location: Arizona
Default

On the flocked dome light? Just some lint and such from me agitating the roof liner. There is some, very minimal, gray showing around the buttons where I didn't take the flocking far enough into the recesses between the button and housing. Again, this was my first attempt at flocking and I may flock further down to cover up the blemish. Certainly not the materials fault though. You can see here I flocked down the sides of the button thinking that would be sufficient but I should have done the same to the adjacent surface of the houseing:

* Registered users of the site do not see these ads.
EnderDragoon is offline   Reply With Quote