Thread: Finally did it
View Single Post
Old 10-27-2012, 06:35 PM   #18
Acro2Pilot
Scooby Newbie
 
Member#: 234617
Join Date: Jan 2010
Default

I have wrapped up the trimming and final details and am now free of rubbing other than the leading edge of the rear of the front wheel well, that needs about 1/4 of an inch of relief before it clears at full lock. I didn't measure the wheel wells before cutting so if someone could as a comparison that would be sweet. The most difficult trim was the front of the rear wheel well at about 1in. Two sheets are bonded at that location and cutting them separates the two I cut the outer one shorter than the inner one so that they would seat with some overlap and then welded them back together. So the current specs are;

Lift; 4in
Front wheel well width at bottom; 32in
Rear wheel well width at bottom; 30 3/4in
Tires; Goodrich Mud TA KM2 235/70-16 (29 inch tires)





* Registered users of the site do not see these ads.
Acro2Pilot is offline   Reply With Quote