View Single Post
Old 10-31-2012, 05:36 AM   #43
jockeygolfs
Scooby Specialist
 
Member#: 260868
Join Date: Oct 2010
Chapter/Region: South East
Location: Lake Worth, Florida
Vehicle:
2011 STI
White

Default

Quote:
Originally Posted by banshee04
Here's my new setup. I added a Walbro, Soldered the two pigtails together, then soldered 10ga wire to the positive and negative wires on the pigtail. The relay is hooked up the exact same, im just not using the factory plug pigtail that plugs into the pump. This way, it doesnt go from 10ga wire to factory wire, Its all 10ga. Since im running 2 pumps not, I didnt add another relay, I just bought a 60amp relay to replace the 30amp relay.
From the pic it does not look like 10 ga wires right above the pump. Those look like the original wires on the pump pig tails then you soldered the two pumps together with the 10 ga wire. Is this correct?

Are the grommets you used on the plate aftermarket? Where did you get those?

Thank you
* Registered users of the site do not see these ads.
jockeygolfs is offline   Reply With Quote