View Single Post
Old 10-31-2012, 02:27 PM   #7
04SUBIWRX
Scooby Newbie
 
Member#: 138872
Join Date: Jan 2007
Chapter/Region: South East
Location: Canton,GA
Vehicle:
2003 WRX Wagon
PSM

Default

It's not that bad. Un-bolt the lower motor mount bolt on each side jack up the motor/tranny and stick a 1" block of wood between the frame rail and the motor mount to keep it up. Make sure you use a 1/4 ratchet with a swivel on the socket end and a extension. That will make getting the back bolts alot easier. I found it easier once you get the bolts out of the oil pan and drop it a little take off the pickup tube. Everything will come out a lot easier.
* Registered users of the site do not see these ads.
04SUBIWRX is offline   Reply With Quote