Thread: Finally did it
View Single Post
Old 11-06-2012, 10:28 PM   #33
Acro2Pilot
Scooby Newbie
 
Member#: 234617
Join Date: Jan 2010
Default

Got the hitch finished today. The one I ordered from Amazon had a set of bolts that was an inch too long and a standard thread instead of the metric thread. I drilled out the welded in nut and picked up matching nuts for the included bolts and got the hitch installed easily. I was a bit worried about the comments that the wiring varied even between years, but the one Amazon listed plugged right up.

I drove the truck today down a tractor trail that runs parallel to the runway at a friend's airstrip. He needed a magneto for the engine on his cub so I drove one down to him. We had run that road at about 30~40 in his Raptor and I ran it both ways in the Baja at 60. I am talking deep ruts, mud holes, and jumps!
* Registered users of the site do not see these ads.
Acro2Pilot is offline   Reply With Quote