View Single Post
Old 11-11-2012, 10:16 PM   #45
jeffie7
Scooby Newbie
 
Member#: 321791
Join Date: May 2012
Chapter/Region: MAIC
Vehicle:
05 STi
Aspen White

Default

When popping ball joints out, another option is to smack whatever the ball joint goes through.


I've had mixed luck with this, but I also use a much smaller hammer, IMO if you can get a puller onto the ball joint, USE IT! however the tie rod ends will not allow you to get a puller on them, either smack what it goes through or back the nut off to the very top of the bolt so its flush and smack it.
* Registered users of the site do not see these ads.

Last edited by jeffie7; 11-11-2012 at 10:22 PM.
jeffie7 is offline   Reply With Quote