View Single Post
Old 11-12-2012, 09:52 PM   #5
gsrcrxsi
Scooby Specialist
 
Member#: 236952
Join Date: Jan 2010
Chapter/Region: MAIC
Location: Baltimore
Vehicle:
2010 WRX (SSM)
Stg "2+" 300hp/360trq

Default

Quote:
Originally Posted by sc00by4life

all 9" grids have the same face.....

all 9.5" grids have the same face.....

the 17x9 +42 is going to be the easiest for you to fit, but you'll still need to roll fenders at the least.
If he goes with the 17x9 +42...

He'll only need to roll the rears. Maybe not even if he stays at stock ride height. He said he wants to stay with stock tire size too. 225/45/17 will stretch a good amount on a 9" rim

I ran/run 17x9 +44 Work CR-Kai with 245/40/17 tires. Lowered about an inch on epic springs, and then again on RCE blacks, I did not have to roll any fenders. It was VERY close but I did not have to roll for fitment and nothing rubbed.

However, after I installed my white line rear subframe and differential bushings (solid poly, not inserts) it started to very slightly rub in the rear so I had them rolled.

Hope this helps.
* Registered users of the site do not see these ads.
gsrcrxsi is offline   Reply With Quote