View Single Post
Old 11-14-2012, 04:29 PM   #59
MRF582
Scooby Guru
 
Member#: 48219
Join Date: Nov 2003
Chapter/Region: MAIC
Location: Pittsburgh, PA
Vehicle:
. Always drive
the race line .

Default

Quote:
Originally Posted by 06rexwagon View Post
The wrist pin worked out far enough to drag along the cylinder wall which was the probable cause of the bearing failure.
Any idea on why the circlip came off? Any chance it was compressed too much during assembly?
* Registered users of the site do not see these ads.
MRF582 is offline   Reply With Quote