View Single Post
Old 11-15-2012, 02:22 AM   #964
armyssoldierboy
Scooby Specialist
 
Member#: 109424
Join Date: Mar 2006
Chapter/Region: South East
Location: Deridder, LA
Vehicle:
06 AW STI
TS HTA 3076r 436hp/426tq

Default

Quote:
Originally Posted by 2point0 View Post
Is there a slight bend in that? Not sure if this will work for you since it's a thick piece, but when I made mine out of sheet steel, I screwed it down onto an old speaker box so the bend line was at the edge, then used a block of wood and a hammer (wood to soften the blow) and gave it some good whacks to make a nice crease. Rubber mallet worked, too, but nicer with a block to make it smooth.
Currently no. I was going to do one of two things. 1 was to enlarge/extend the radiator brack bolt hole down some so as to not put as much stress on the radiator tabs or 2 bend it in which I'll still need to do 1's option as well. I would ultimately like to make two sharp bends like what GrimmSpeed did on there's. 90* bend at the end of radiator for 1/8'' to another bend, 80ish*...flush with the chassis lol
* Registered users of the site do not see these ads.
armyssoldierboy is offline   Reply With Quote