View Single Post
Old 11-17-2012, 08:14 PM   #3538
Smurftastic
Scooby Specialist
 
Member#: 243697
Join Date: Apr 2010
Chapter/Region: MAIC
Location: Virginia
Vehicle:
02 Stg2+ WRX
Top Scoob 031

Default

I used to run an FMIC. IMO the best way to ensure minimal cutting and keeping it clean is making initial measurements following a test fit, and then cutting as minimally as possible. Test fit again to get some final measurements and make an effort to make the final cuts as straight as possible.

Although you are only like an hour from Mach V and I'm sure they would do a superb job.
* Registered users of the site do not see these ads.
Smurftastic is offline