View Single Post
Old 11-26-2012, 07:33 PM   #1
metacortex
Scooby Newbie
 
Member#: 139859
Join Date: Feb 2007
Chapter/Region: RMIC
Location: Northern Utah
Default Figuring out a cut v7 JDM harness

Recently picked up a JDM v7 front clip and am going to be putting everything in my '00 RS. I haven't started the swap yet but I am running into an issue where the wiring harness going to the rear was cut and I have a bundle of wires that I don't know their end destination.

I have spent a couple hours trying to find somewhere that maps wire colors to component so I can get everything merged but I have been unsuccessful. Does anyone have any info on this?
* Registered users of the site do not see these ads.
metacortex is online now   Reply With Quote